| Message | Comments |
|---|---|
| Century error. | |
| Total of forest C fractions is not equal to 1. | |
| Error in ran1: j > 97 or j < 1 | |
| Microcosm is available for cropping system only. | |
| Error calculating solution mineral P fraction. | |
| Option parameter count is not what is expected. | |
| Invalid rate value in an erosion event. | |
| Memory allocation error. | |
| Output variable class has invalid float count. |
| Message | Comments |
|---|---|
| Error reading the parameter type parameters file. | The parameter type is one of the following: tree, tree removal, crop, cultivation, fertilization, fire, grazing, harvest, irrigation, org. matter, or fixed. |
| Message | Comments |
|---|---|
| parameter type option not in the parameter file. | The parameter type is one of the following: tree, tree removal, crop, cultivation, fertilization, fire, grazing, harvest, irrigation, org. matter, or fixed. |
| Message | Comments |
|---|---|
| Unable to open the weather file. | |
| Error reading the weather data file | |
| Weather file has data that is out of sequence. |
| Message | Comments |
|---|---|
| Management scheme failed verification. | |
| Management scheme has no block definitions. | |
| Management scheme has no instances of blocks. | |
| Weather source = file, but no file name given. | |
| Block instance start year != to simulation year. | |
| Block has no instances in simulation time. | |
| Management scheme has not been specified. | |
| Error in the management scheme. |
| Message | Comments |
|---|---|
| Site parameter set has not been specified. | |
| Site parameter set is empty. | |
| Site parameter NLAYER is too large. | |
| Unable to initialize the physical soil. | |
| Error in the site parameters. |
| Message | Comments |
|---|---|
| Output file of the same name already exists. | |
| You did not specify an output file name. | |
| Invalid output file type was specified. | |
| Previous output file is missing or invalid. | |
| Unable to open the output file. | |
| Error writing to the output file. | |
| Invalid output file access mode was specified. | |
| Invalid output file format was requested. | |
| Unable to access output variable descriptions. |
| Message | Comments |
|---|---|
| Flow stack: Maximum size was exceeded. | |
| Flow stack: Value of the source variable < 0. | |
| Flow stack: Amount to flow is too large. |
| Message | Comments |
|---|---|
| Error reading the 14C data file. | |
| 14C data file cannot match labeling year. | |
| 14C data file name was not specified. | |
| Unable to access the 14C data file. |
| Message | Comments |
|---|---|
| Invalid erosion file name specified: | |
| Invalid deposition file name specified: | |
| Deposition event without an erosion input file. |