Running the Century Simulation

You can run your simulation either from the Century Model Interface (CMI), or from the command-line prompt in a shell, or console, window.

To run a simulation in CMI, perform the following sequence of actions:

1. Specify the site parameters.
2. Specify the management scheme.
3. Specify the output file.
4. Check the simulation status to be sure your configuration is correct.
5. Run the simulation.
6. Examine the results.

Both the CMI and Century programs accept the same set of command-line options. See the Running Century and CMI with Command-Line Options for details on command-line execution of Century and CMI.

See Also

Preparing for a Simulation
Examining the Simulation Results
Troubleshooting Your Simulation Configuration